Insights

Commercial roofing insights

Practical guides for property and facility managers, how commercial roof systems compare, when to coat versus replace, and how to plan your roofing budget with confidence.

Guides & insights

Repair or Replace? In uncertain economic times, the right roofing solution is not always a full replacement. Read article → The 48-hour rule for commercial flat roofs If water is still sitting on your roof 48 hours after a storm, that isn't drainage. That's ponding. Read article → Why would you leave 20°C on the roof? Cutting a roof's surface temperature by 20°C (36°F) is routine for a reflective coating. The question is why you'd leave that on the table. Read article → TPO vs. EPDM: which single-ply is right for your building? Two of the most common commercial flat-roof membranes, compared on the things that actually matter in Ontario. Read article → Coat or replace? How to know if restoration is right for your roof A restoration coating can add a decade of life at a fraction of a tear-off, but only if your roof meets strict criteria. Here's how we decide. Read article → How long should a commercial flat roof last? Service life depends on the system, the install and, more than anything, how the roof is maintained. Here's what drives the number. Read article → How to Know When a Commercial Roof Needs Full Replacement Age does not decide when a commercial roof needs replacing — the pattern of repairs does. Here is how to tell a roof with failed details from a roof that is genuinely finished. Read article → When to Choose Skylight Systems Over Traditional Roof Lighting Skylights are a roofing decision that happens to produce light. Judged as a lighting upgrade they usually look expensive; judged as roof detailing with a daylight benefit, the question becomes a sensible one. Read article → Emergency Roofing Services: When to Call and What to Expect Not every roof problem is an emergency, and the first visit is not a repair. Knowing what actually warrants a call — and what a stabilisation visit is meant to achieve — makes the whole thing go faster. Read article → Why Flat Roof Leaks Spread Fast in Commercial Buildings The stain is not the hole. On a commercial flat roof water enters in one place and appears somewhere else entirely — which is why a small ceiling mark is a poor guide to how much roof is wet. Read article → What Facility Managers Should Do in the First Hour of a Roof Leak The first hour of a roof leak is not for diagnosing the roof. It is for protecting people, limiting what the water reaches, and recording what a contractor will need — because that evidence disappears fast. Read article → How Detailed Roof Condition Reports Support Better Capital Planning A roof report that says the roof "looks worn" is useless for planning. The one you need answers a harder question: which budget year does this roof belong in, and what does it cost to postpone it? Read article → Infrared Drone Inspections, A Smarter Way to Detect Flat Roof Moisture You cannot see wet insulation from the surface of a flat roof. A thermal scan can — it reads the heat that saturated insulation holds after sunset, which is how a small breach gets found before it becomes a large one. Read article → The Hidden Cost of Deferred Roof Maintenance for Industrial Facilities Deferring roof maintenance does save money — until it does not. On an industrial building the roofing invoice is rarely the expensive part; the disruption underneath it is. Read article → How Routine Commercial Roof Inspections Cut Energy Waste in Buildings A roof does not have to leak to cost you money. Wet insulation stops insulating long before anything shows up on a ceiling — and you pay for it every month in heating and cooling. Read article →

More guides are on the way. Have a question about your roof? Ask our team →